mode hibernation/sleep

Discussion in 'UDOO X86' started by Darknain, Apr 13, 2018.

  1. Darknain

    Darknain New Member

    Joined:
    Mar 7, 2018
    Messages:
    24
    Likes Received:
    2
    Hello,

    I am having an issue with my udoo x86.
    I was uploading a sketch to the arduino 101 and I accidently switch off the power.
    When I powered it on again the led became orange.
    I verifyied the voltage I have 5V_ALW and 3.3V_ALW.
    However I don't have the 5V_C and 3.3V_C which seem to be due to cause the inexisting signal curie_power_en.
    I tried everything like power it off and de energizing then power it on and press the two buttons to wake the card. I removed everything connected to the card and powered it on.
    When the led is orange it draws 0,11 A.
    I don't know what to do to wake up it from this sleep mode.
    I don't have any video output.
    And all my work is on the udoo I can't get access to it.

    Thanks for you help
     
    Last edited: Apr 13, 2018
  2. waltervl

    waltervl UDOOer

    Joined:
    Dec 12, 2015
    Messages:
    2,306
    Likes Received:
    578
    If you press ESC, ESC etc during boot you should be entering the UEFI menus where you can set boot options.
     
  3. Darknain

    Darknain New Member

    Joined:
    Mar 7, 2018
    Messages:
    24
    Likes Received:
    2
    I tried pressing ESC but nothing happenned and I still have no video output on the screen
     
  4. waltervl

    waltervl UDOOer

    Joined:
    Dec 12, 2015
    Messages:
    2,306
    Likes Received:
    578
  5. Darknain

    Darknain New Member

    Joined:
    Mar 7, 2018
    Messages:
    24
    Likes Received:
    2
    I already did it, I unplugged the RTC battery, the power and all the devices.
    I let the board rest during one night and tried the other day but still the led is orange.
    If I can't wake up it from this sleep mode Can I at least get access to the files stored on the board somehow?

    If I connect the udoo x86 to my pc through usb, will I detect it and will be able to get access to the files stored on the emmc ?
     
    Last edited: Apr 14, 2018
  6. waltervl

    waltervl UDOOer

    Joined:
    Dec 12, 2015
    Messages:
    2,306
    Likes Received:
    578

Share This Page