hello dear Community fairly new to udoo. a friend of me wants to sell me a Udoo Quad Makerboard Rev. D. question: can i connect this to a SATA Board !? Note i want to build up a NAS/ Samba server. can i do that with this UDoo quad found the following specs CPU NXP i.MX 6 ARM Cortex-A9 Quad core 1GHz GPU Vivante GC 2000 + Vivante GC 355 + Vivante GC 320 Integrated accelerators for 2D, OpenGL® ES2.0 3D and OpenVG™ Atmel SAM3X8E ARM Cortex-M3 CPU (same as Arduino Due) RAM DDR3 1GB 76 fully available GPIO: 62 digital + 14 digital/analog Arduino-compatible R3 1.0 pinout HDMI and LVDS + Touch 2 Micro USB (1 OTG type a+b) 2 USB type A (x2) and 1 USB connector (requires a specific wire) Analog Audio and Mic CSI Camera Connection on board Micro SD card reader (boot device) Input Voltage (recommended) 6-15 V Ethernet RJ45 (10/100/1000 MBit) WiFi Module SATA are they still correct - and do the describe the Rev D too!?
