XDP or DCI Debug on Braswell?

Discussion in 'UDOO X86' started by XeNo, Oct 14, 2018.

  1. XeNo

    XeNo New Member

    Joined:
    Oct 14, 2018
    Messages:
    1
    Likes Received:
    0
    Hi
    I would like to get Jtag debug on the braswell?

    As its connected to the Currie (I think) via USB, does accesing the Jtag on the Currie allow debug on the Braswell e.g the Braswell another device in the chain?

    I see in the schematics that XDP jtag on the Braswell is connected but lines are either pulled high or low via resistors. Can removing R106 to R111 and adding connections manually allow XDP debug access to the Braswell?

    Regards
    Robert
     
  2. ccs_hello

    ccs_hello UDOOer

    Joined:
    Apr 15, 2017
    Messages:
    536
    Likes Received:
    194
    That JTAG connector is only connected to Curie (Arduino 101), and unrelated to Braswell.
     

Share This Page